Arado 196 Revell 1/32

[No.1]

As you have seen in our topic about new acquisition, I get this one few months ago but due to many other things, I was not able to start it before. Sorry, I forget to take image of box, will do that tomorrow. This is very start and on very start I hurt my finger...   

[No.1]

Little work on cockpit elements

[draken35]

Is your finger OK?

Nice work anyway...

[modellius]

Interesting subject and a great start

[No.1]

Thanks friends Yes, finger is operational now, I slice surface with grinder and very sharp tool inside

[No.1]

Work on seat belts

[No.1]

I work on interior and there is some problems. Main interior is look like RLM 66 and main problem could be radio unit which can be in the same color as well in Gerategrau (bluish version)

[No.1]

Here it is situation in the moment and I have problem to flat down decals over raised surface of instruments... 

And there is one visitor

[draken35]

Eventually try with an hair dryer... Not too short distance to avoid the parts to be deformed

[No.1]

I try something other- they lay down a bit then I penetrate film with razor blade and put more decal setting liquid. Wait few hours then releat and until now they lay down much but I will need more extra work to finalize that

[draken35]

I try something other- they lay down a bit then I penetrate film with razor blade and put more decal setting liquid. Wait few hours then releat and until now they lay down much but I will need more extra work to finalize that

It's also a good technique. More time spending, but will give excellent results.

[No.1]

Best solution is to use Superscale fluid for decals, ultimate one

[No.1]

Still work on cockpit, focus on seat belts

[draken35]

Strabge, I cannot see your photos this time...

[No.1]

Problems.....